Motorcycle Warehouse
Battery Reconditioning
How Do They Work?
Using breakthrough square wave technology, These
electronic devices send a frequency signal to each crystal of lead
sulfate, causing it to dissolve into lead and sulfuric acid. This process is what
recondtitions your battery and
allows the electrical charge to be drawn from the battery
again.
These battery reconditioning units can be used for the following
applications:
• To recondition a dead or barely usable
battery, connect the electronic
device to the battery, along with your battery charger. A 6 - 10 amp
charger works best. This electronic device is powered by the battery and
only two wires need to be connected, one to each terminal of the battery.
Allow the battery to charge until the specific gravity reaches between
1.250 and 1.300. This would be equivalent to a new battery. If you don’t
have a hydrometer to measure specific gravity, you can check the voltage
while the battery charger is on. If the voltage is over 15 volts, the
battery is fully reconditioned. This process takes from 24 hours to as
much as several days for a badly sulfated battery. We offer a Battery
Reconditioning Service if you do not want to recondition your own battery.
You can drop off your battery and we will recondition it for you. We also
sell reconditioned batteries for 40% of the cost of a new
battery.
• To accelerate the de-sulfating process, turn the battery charger off if the
battery voltage is at least 11.5 volts. Leave the electronic device
connected and allow it to run by itself for 12 hours. Then turn the
battery charger on and allow it to run for 12 hours with the battery
charger on. Do this alternately until the specific gravity is within
range.
• To maintain working batteries, install the electronic device on each battery or bank
of batteries. It rejuvenates the batteries while the vehicle is operating.
This causes more power to be available from the battery and causes less
power to be needed to charge the battery. This is the best way to extend
the life of your batteries. It’s like having a brand new battery every
time you start your vehicle.
Applications/Models To Recondition
Your Battery
These electronic devices are
suited to all types of lead acid batteries -
Flooded, Gel, and AGM. It
can be used on
individual batteries and battery banks of all
sizes. They
are reverse polarity protected - if they are hooked up in reverse, they
will draw current but will not damage the battery or themselves. The case
is isolated. They can be used in parallel with a charging source. Each
unit is approximately 4.5 inches wide by 2.25 inches deep by 2 inches high
and weighs 11.4 ounces. The electronics are potted in an anodized aluminum
heat sink, protecting them from the environment.
BLS - 36A
For use with 36 volt battery powered vehicles. Can be
mounted on the vehicle to constantly keep the batteries in optimum
condition or can be used in conjunction with a battery charger to
recondition your batteries. Comes with 3/8 lugs for attachment to the
battery terminals. Maximum current draw 0.5 amps; average 0.25 amps.
Voltage window: 12 volts to 45 volts. $119.95
BLS - 48A
Ideal
for 48 volt renewable energy battery banks or use with battery powered
vehicles. Ideally mounted full time to constantly keep the batteries in
optimum condition or can be used in conjunction with a battery charger to
recondition your batteries. Comes with 3/8 lugs for attachment to the
battery terminals. Maximum current draw 0.5 amps; average 0.25 amps.
Voltage window: 24 volts to 65 volts. NOTICE: Use the BLS-48-B for Club
Car 48 volt golf carts. $119.95
BLS -
48B
Especially designed for Club Car and
Yamaha 48 volt models with on board computers. Ideally mounted full time
to constantly keep the batteries in optimum condition or can be used in
conjunction with a battery charger to recondition your batteries. Comes
with 3/8 lugs for attachment to the battery terminals. Maximum current
draw 0.5 amps; average 0.25 amps. Voltage window: 45 volts to 65
volts. $119.95
BLS -
72A
For 72 Volt NEV's like the Gem car by Chrysler
and Think by Ford. Ideally mounted full time to constantly keep the
batteries in optimum condition or can be used in conjunction with a
battery charger to recondition your batteries. Comes with 3/8 lugs for
attachment to the battery terminals. Maximum current draw 0.5 amps;
average 0.25 amps. Voltage window: 65 volts to 85 volts. $119.95
BLS -
24/36 Multi-Volt
It is
similar to the 12/24-B except it works for 24 and 36 volt battery systems.
Ideally mounted full time to constantly keep the batteries in optimum
condition or can be used in conjunction with a battery charger to
recondition your batteries. Comes with 3/8 lugs for attachment to the
battery terminals. Maximum current draw 0.5 amps; average 0.25 amps.
Voltage window: 24 volts to 65 volts. $209.95
BLS - 36/48 Multi-Volt
For forklift
batteries. The electronic device is enclosed in an insulated housing to
prevent shorting on top of the battery Mounted full time to constantly
keep the batteries in optimum condition or can be used in conjunction with
a battery charger to recondition your batteries. Comes with 1/4 lugs for
attachment to the battery terminals. Maximum current draw 0.5 amps;
average 0.25 amps. Voltage window: 24 volts to 65 volts. Installed with
#10 self tapping screws drilled into the battery terminals. $209.95
BLS -
12A
For use on 12 volt systems. Ideal for 12 volt
vehicle battery systems. Runs constantly to keep the battery in optimum
condition. Can also be used for battery storage in conjunction with a
float charger. Comes with eye rings for attachment to the battery clamp
bolts. Maximum current draw 0.1 amp; average 0.06 amps. ONLY FOR USE ON A
MOTOR VEHICLE. $74.95
BLS -
12/24B
This is our most popular
model. Ideal for 12 and 24 volt
renewable energy battery banks. Also ideal for use with a battery charger to
recondition unusable batteries (will work even if battery is at 4 volts). Comes with
alligator type battery clips. Maximum current draw 0.25 amps at 12 volt
and 0.5 amps at 24 volts; average 0.125 amps and 0.25 amps at 12 and 24
volts, respectively. Voltage window: 4 volts to 35 volts. This is the only
electronic device designed to recover totally dead
batteries. $119.95
BLS -
12/24C
For use on heavy trucks and other vehicles with
multiple batteries up to 4 batteries. Runs constantly to keep batteries in
optimum condition. Comes with 5/16 lugs for attachment to the battery
clamp bolts. Maximum current draw 0.5 amps; average 0.25 amps. ONLY FOR
USE ON A MOTOR VEHICLE. $119.95
Parts and Accessories for Cruisers, Sport Bikes and Enduros